Dyneema® Arm Protection is Cool! One of the most distinguishing Dyneema® characteristics is its cool-to-touch property. Dyneema® fibers inherent ability to dissipate body heat and pass moisture from inside of the sleeve to the outside, results in longer wear time which promotes greater protection. The 9318DT10 is a 10 gauge Dyneema® Diamond Technology sleeve with Silicone grid coatings and is 18 inches in length. The silicone grid coatings provide exceptional grip and abrasion resistance. Looking for the best cut resistant sleeves? Look no further than MCR Safety.
- ANSI Cut Level A4
- ANSI/ISEA 105:2016 Standard
- ASTM F2992-15 Cut Resistance Test Method
This tear score was derived from the EN 388:2016 standard. The European Standard EN 388:2016 covers the test requirements for safety gloves that are provided to protect against mechanical risks.
- ANSI Abrasion Level 6
- ANSI/ISEA 105:2016 Standard
- Abrasion Resistance Test Method ASTM D3389-15 for Coated Gloves
- Abrasion Resistance Test Method ASTM 3884-09 for Uncoated Gloves
For applications less than 284 degrees Fahrenheit. Contact Heat Only, Not Direct Flame.
-Gloves Tested Palm Only-
ANSI/ISEA 105:2016 Standard, ASTM F1060 - 18 Standard Test Method for Evaluation of Conductive and Compressive Heat Resistance. Conductive heat ratings measure the highest contact temperature for which the time to second-degree burn is at least 15 seconds and the alarm time is at least four seconds.
Every day consists of change and improvement so at MCR Safety we are living this out by updating the most powerful cut protection offerings in the industry with a single brand that represents the best of the best in fibers, coatings, and technology advancements as CUTPRO. One unified brand identity along with an easy identifiable ANSI cut scoring system.
10 Gauge
No
Dyneema
Silicone
A4
6
2
No
4
4
4
X
Yes
18 in.
Black
Gray
Knitted
120
33.720
Black Polybag 10
0.281
